Ducati 999R User Manual download pdf (Page 6)

INSTALLING THROTTLE/BRAKE LINKAGE

Skip if already assembled in RTR version

a. Build the throttle/brake linkages as shown in the diagram.

b. Install the kinked linkage end onto the carburetor lever, and secure the disc brake wire onto the

pivoting linkage collar with 1.5mm set screw.

c. Install the throttle servo horn onto throttle servo output shaft.

d. Secure the disc brake wire onto the brake lever on the rear disc brake with a 1.5mm set screw.

Optional Front Disc Brake (Purchase separately)

a. Build the front disc brake as shown in the diagram. Use a 3 mm hex wrench to detach the right

front plastic disc brake off the front forks.

b. Mount the disc brake and brake pad where the plastic disc brake is mounted. Sandwich the brake

disc between the brake pads. Secure the disc brake wire onto the pivoting linkage collar with

1.5mm set screw.

c. Route the disc brake wire through the supplied steel spring tubing and the vented window section

on the chassis frame. Secure the disc brake wire onto the brake lever and a linkage collar on the

front disc brake with a 1.5mm set screw.

Apply CA Glue

on the outer brake pad

Apply CA Glue

on the inner brake pad

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

No comments

Ducati 999R User Manual Page 6